PS-10 Interruptor electrónico Aucun produit dans cette catégorie.

PIC-MODEL
PS-10 electronic switch
Instruction Manual
Please read this manual before using your electronic switch.
This switch is designed to turn any source of voltage, specially designed for use as a power switch for models (airplanes, boats, cars, etc.), replacing the mechanical switch Ignition is fully electronic with the security to failures by bad contacts, humidity etc vibrations. is total. Can operate even in the water.
Connection:
Connect the battery to the 2-wire female connector (red wire + and - black wire, if the polarity at the input, the output will always enabled while the LED is off) the male connector plug the receiver in making battery or you want to control circuit (bec, u-bec etc). In the three-wire socket, connect the switch or the magnetic sensor. For operation with the sensor reads the accompanying manual.
Open a 8 mm drill to place the power indicator to open it vigorously pull the flat in one direction and round the other, turning at the same time then to mount the cylindrical type outside the fuselage and flat inside, if necessary, use an adhesive
To switch on or off continuously about 2 seconds press the button, if it was off the switch and turn on the LED, leading current, if it was on will turn off both and cut the power supply.
It has additional security, if for whatever reason, all power to the switch and therefore the model when lit, by ruling, in a connector or battery, reset voltage, the switch will turn on automatically, and if it was off, will remain off until you activate it through the switch. If the electrical connection is broken-off for some reason this does not affect the ignition switch in the event that was on, but it happens that you can not turn on / off, for it will have to repair the electrical connection.
The contact type switch is open, ie, to activate it have to click on it,
so it is very unlikely that vibration is close contact and even less for 2 consecutive seconds, resulting in very high reliability.
It is not necessary to disconnect the battery, because thanks to its low power consumption can be connected without draining it a long time. (Off).
output short circuit, this will cause serious damage to the battery and its electronic switch, this damage is not covered by warranty.
Avoid excessive vibration, shock ...
Electrical Specifications
Input:
Feeding
Consumption Max 1mA off without sensor
Consumption off with max 2.5 mA sensor
Power consumption 20 mA Max
Check out:
Voltage input: minimum 3.5 VDC
Input voltage: maximum 20 Vdc 30 Vdc peak
Current: 5 Amp maximum continuous
visit us at www.pic-model.es