Manual Y-BAT There are no products.

PIC-MODEL



Manual Y-bat:
Please read this manual thoroughly before using your Y-BAT.
The Y-BAT in a double-feed input and single output without voltage regulation.
Double feeder is possibly the safest on the market, thanks to technology. With a maximum voltage drop of only 0.3 Vdc
The Y-BAT, two batteries connected in "parallel" but without the typical problems arise from this union, namely the loading or discharging of a battery at the expense of the other, failure of both batteries etc if one is shorted.
By design these problems are not present, so as to provide a constant power while one or two batteries are connected.
You can make various combinations of batteries, as indicated later.
The LEDs indicate the battery is connected and a voltage above 2.5 volts.
The voltage is in the output corresponds to the battery that is more charged, that is, if we connect two batteries, one of Li-po 2 S (7.4 volts) and a 4 Ni-Mh (4.8 Vdc) the output voltage will be a 7.4 Vdc.
If failure or battery discharge below 4.8 volts on the output is the voltage battery belonging to the Ni-Mh 4.
If the battery voltage is more, it suddenly breaks down or is discharged, the output will not notice the battery change as there is no switching time, it is virtually instantaneous, so that our receiver, no have any type of fault for this, in the case of 2.4 GHz equipment is especially useful because it prevents the problems caused by cuts or brownouts.

Features:
Input voltage 25 VDC maximum
Output current 15 Amps maximum heatsink

Output current sink 2.5 amps continuous without and 11 VDC maximum.

Power consumption 20 mA maximum LED
Power consumption 0 mA without LED
Made in Spain
Visit us at www.pic-model.es